🛠️ INSTRUCTIONS FOR USE:
1️⃣ Surface preparation:
For larger defects – pre-treat with NIGRIN filling filler
For small defects – remove rust, degrease, clean, and sand the surface
2️⃣ Mix NIGRIN Fine Polyester Filler with hardener in a 98% filler : 2% hardener ratio
👉 Recommendation: golf-ball-sized amount of filler + pea-sized amount of hardener
3️⃣ Mix thoroughly and apply quickly
⏱️ Working time:
Start of hardening: after 5–6 minutes
Full curing: approx. 30 minutes
After curing: sand the surface
✨ Result / Effect:
✔️ Hardens without cracking
✔️ Smooths scratches and minor dents
✔️ Suitable for finishing previously filled areas
✔️ Provides an exceptionally smooth surface
⚗️ COMPOSITION:
25–50% Dibenzoyl peroxide
⚠️ HAZARD WARNINGS:
👁️ H319 – Causes serious eye irritation
🧴 H317 – May cause an allergic skin reaction
🔥 H242 – Heating may cause a fire
🌊 H400 – Very toxic to aquatic life
🌍 H410 – Very toxic to aquatic life with long-lasting effects
🛡️ SAFETY PRECAUTIONS:
ℹ️ P101 – If medical advice is needed, have the product container or label at hand
🚫 P102 – Keep out of reach of children
🔥 P210 – Keep away from heat, hot surfaces, sparks, and open flames. No smoking
🌍 P273 – Avoid release into the environment
🧤 P280 – Wear protective gloves, eye protection, and a mask
👁️ P305 + P351 + P338 – IF IN EYES: Rinse cautiously with water, remove contact lenses if present and continue rinsing
👁️ P337 + P313 – If eye irritation persists: Get medical advice/attention
🧴 P302 + P352 – IF ON SKIN: Wash with plenty of soap and water
🩹 P333 + P313 – If skin irritation or rash occurs: Get medical advice/attention
❄️ P411 + P235 – Store in a cool, dry place (below 30°C)
🗑️ P501 – Dispose of contents/container in accordance with local regulations
There are no reviews yet.